#semicircular Tumblr posts

  • https://amazing-handmade.tumblr.com

    How to sew a skirt-the sun and the bell. MK

    When sewing this skirt uses a very simple pattern. But everything in order.

    Building pattern skirts flared sun

    In order to build the pattern and sew this skirt, you will need to take two measurements:
    Sweat (poluobhvat waist) and Du (skirt length). For example, take the Pot = 34 cm and Du = 68 cm.
    Pattern skirts flared the sun is a circle with a Central recess, the radius of which is calculated as one third of poluobhvat waist minus 1 cm:
    R = 1/3 * 34 - 1 cm = 11 cm.

    Depending on the available width of the fabric, the skirt pattern flare the sun can be build either with two seams, or no seams.

    1. The sun flared skirt with two seams. Fabric width 80+ see

    For sewing skirts will need a piece of fabric with a length equal to four lengths of the skirt plus 4 radius recesses at the waist plus 10 cm

    Unfold the fabric and place along the top edge Du (the skirt length, plus allowance for ACC 2-3 cm, then the radius of the recess. Note the point A. From her conduct circles of radii R and R+Дю3 cm allowance for ACC).

    The sides of the recess under the waist increased by 1 see Also, don’t forget about allowance for ACC 2-3 cm

    Seams can be both front and rear, and sides of the skirt flare the sun.

    Top pattern with two seams for cutting on narrow fabrics. The lower pattern without seams, cutting for wide fabric, folded in half.

    2. The full skirt sun without seams. Fabric width 152 cm

    For sewing skirts will need a piece of fabric equal to twice the length of the skirt plus 2 radius recesses at the waist plus 10 cm

    The pattern is constructed in the same way as in the previous case, however, due to the fact that the fabric width of 152 cm, folded in half will give a carriageway width of 76 cm, which may not be enough for full length skirts have missing pieces to find separately.
    Made paper pattern skirts flared sun is applied, in the case of sewing without a seam, the longitudinal fold of the fabric.

    Tailoring skirts

    Sativum, and then grind the side (front/rear) slices, leaving one unsewn 16-20 cm at the clasp.

    Ormative slices and machined clasp.

    The upper section of a process belt or grosgrain tape, cut a little at the same pripasaem.
    Will do the fitting, after which process the bottom of the skirt. After sewing, Ataturk skirt.

    BELL SKIRT

    The proposed pattern skirt polyanna sewn with only one seam (not counting, of course, of machining the edges and clasp)! You can choose to wear a skirt seam forward or backward. Due to the fact that the skirt is sewn perpendicular to each other directions of the fabric, it is not recommended to use for sewing the cloth in a cage, or unilateral direction of the figure, as it won’t match in the seam.

    Building patterns

    Pattern skirts bell bottoms the bell is a quarter of a circle (the fabric will be in half circle) with a Central recess under the waist.

    For the construction of the pattern this skirt will need to remove the following measurements:
    Poluobhvat waist (Sweat) and skirt length (Du).

    For example, take the Pot = 34 cm and Du = 68. Increase to free fit at the waist (PT), we take equal to 1 cm.

    The radius of the recesses for the waist R is calculated as 1/3 * (Pot +PT) * 2 - 2 cm standards, R = 1/3 * (34 + 1) * 2 - 2 cm = 22 cm

    Cutting skirts bell bottoms the bell

    In order to sew the flared skirt of the bell according to this pattern, you will need a piece of fabric with length equal to 2 * (Du + R) + 10 cm According to the standards example, 2 * (68 + 22) + 10 cm = 190 cm
    Wide piece of fabric must be Du + R + 5-6 cm By the standards example: 95-96 see If the fabric width is less, you can neumaticos a part of a lower edge positioned on scraps of fabric.

    A piece of fabric folded in half on the narrow side. To the top corner from the bend make the skirt pattern flare of the bell. From the vertex of the angle (in the figure marked (A) is a circle of radius R. At the top edge of fabric cut to the waist extending to 1 cm at the center - 2 cm

    Do not forget about the allowances for bending the upper and lower edge of our skirt the bell, which is 2-3 cm.

    External image

    External image

    External image
    View Full
  • mda’ phyed byas pa - arrow w sharp semicircular head [IW]

    View Full
  • dsfkjfxkkgf

    View Full