!!! FINALLY, A PROPER DICC UPDATE!!
I FINISHED REMODELLING THE RUDY WEREWOLF DICK!
[image ID: 7 cropped screenshots of a digital 3d model of a knotted dildo. All the screenshots are in greyscale, and show a different angle. The first and second screenshots are a side profile view of the model, showing the small ridges on the side of the model. The third screenshot is a direct front view, showing that the tip of the model has a slight angle to it, and that there is a small protruding ridge running along the middle front from under the tip to where the knot starts. The fourth screenshot is an angled side view of the back of the model, showing that there's another ridge along the middle of the back. The fifth screenshot is a front facing pose again, this time at a slight angle. The sixth is another front slash side angle, this time the entire model is askew, with the tip pointing up and to the right. The last screenshot is a left side angle view, with the tip pointing to the left, the model is nearly horizontal. /End ID] I hope I didn't miss anything in the description there.
Update though! I've finally managed to get the first 3d model done!! It's still a dildo version because I need to make sure the shapes work At All before I even begin to work on making them ready for everyday were(beast). This one Should have a shaft length of about 14 to 15 cm, including the knot.
Today, I'm going to finally pick out a top 5(?) of 3d printers. And, hopefully, either this evening or tomorrow, I'll have ordered a printer!
I'm Super excited at the prospect of being able to make some Proper moulds again and that This Time, it won't end up breaking when I remove it from the mould.